WiMAX Bandwidth Request (BW REQ) Procedure

wimax
bandwidth request
bw req
uplink
mac layer

In a WiMAX system, the Subscriber Station (SS) initiates a ranging procedure to establish a connection with the Base Station (BS). This ranging procedure encompasses various types primarily intended for synchronization and maintaining the RF link.

After the ranging process concludes, the Base Station awaits the SBC-REQ message transmitted by the WiMAX SS. The SS uses the SBC-REQ message to inform the BS of its basic capabilities.

Unlike the ranging request (RNG-REQ), there isn’t a dedicated slot for bandwidth requests and SBC-REQ.

Bandwidth requests can be transmitted anywhere within the uplink subframe, except for the reserved ranging slot. The WiMAX BS responds to the bandwidth request in the subsequent broadcast message, informing the SS when it can transmit the SBC-REQ message in the uplink subframe.

The following figure illustrates the contents of the WiMAX bandwidth request header message:

bandwidth request header Image alt: bandwidth request header

Let’s break down the fields within this header:

  • HT (Header Type): 1 bit (0 for Bandwidth Request MAC Header and 1 for generic MAC header)
  • EC (Encryption Control): 1 bit (always 0, indicating no encryption)
  • TYPE: Indicates whether the request is incremental or aggregate.
    • 000 = for incremental
    • 001 = for aggregate
  • BR (Bandwidth Request): 19 bits - The number of bytes of uplink bandwidth requested by the SS.
  • CID (Connection Identifier): 16 bits - Indicates the connection for which uplink bandwidth is being requested.
  • HCS (Header Check Sequence): 8 bits

The Bandwidth Request (BW REQ) Protocol Data Unit (PDU) consists solely of the Bandwidth Request Header and does not contain a payload.

BW REQ Header: Requests refer to the mechanism that SSs use to indicate to the BS that they need uplink BW allocation. Because the uplink burst profile can change dynamically, all requests for BW shall be made in terms of the number of bytes needed to carry the MAC Header and payload, but not the PHY overhead.

As mentioned previously, the BW REQ message can be transmitted during any uplink allocation, except during any initial ranging interval. Bandwidth is always requested on a CID basis, and bandwidth is allocated on an SS basis.

Overview of IEEE 802 Wireless Standards

Overview of IEEE 802 Wireless Standards

Explore the IEEE 802 standard family for LANs, MANs, and WANs, including 802.11 (WLAN), 802.15 (Zigbee, Bluetooth), and 802.16 (WiMAX).

ieee 802 standards
wlan
wimax
WiMAX MAC Protocol: An In-Depth Introduction

WiMAX MAC Protocol: An In-Depth Introduction

Explore the WiMAX MAC protocol, covering convergence, common part, and security sub-layers. Learn about frame structure, scheduling, MAC layer messages, and network entry procedures.

wimax
mac layer
protocol stack
WiMAX Protocol Stack: Layers and Functions

WiMAX Protocol Stack: Layers and Functions

Explore the WiMAX protocol stack, including the physical, MAC, and upper layers. Learn about their functions and how they enable WiMAX communication.

wimax
protocol stack
mac layer