Terminology » Networking Basics » ATDMA in DOCSIS: Advantages and Disadvantages

ATDMA in DOCSIS: Advantages and Disadvantages

docsis atdma tdma cable modem networking

This page explores the benefits and drawbacks of Advanced Time Division Multiple Access (ATDMA) as used within the DOCSIS (Data Over Cable Service Interface Specification) standard.

What are TDMA and FDMA?

TDMA (Time Division Multiple Access), FDMA (Frequency Division Multiple Access), and CDMA (Code Division Multiple Access) are all multiple access techniques. These techniques are crucial for resource allocation, allowing multiple subscribers or users to share access to a shared medium or channel.

  • FDMA: Divides the allocated frequency spectrum into distinct carrier frequencies, each referred to as a “channel.” These carrier frequencies are separated by a channel spacing to prevent interference. FDMA enables simultaneous operation by multiple subscribers, each using a unique frequency.

    FDMA in GSM900 Figure-1: FDMA in GSM900

  • TDMA: In the TDMA scheme, multiple subscriber devices (like cable modems) share the same RF channel but utilize different time slots.

    ![TDMA-Time Division Multiple Access](../../assets/TDMA-Time Division Multiple Access.jpg) Figure-2: TDMA in GSM900

    As the figure illustrates, GSM channels are assigned time slots; with each channel having multiple slots that are used by different subscribers. TDMA is also implemented in DOCSIS networks for communication between cable modems and CMTS (Cable Modem Termination System).

What is ATDMA?

DOCSIS 1.x employs TDMA multiplexing at the Physical layer. This allows cable modems to share the same RF carrier frequency (i.e., channel) during different time slots. In DOCSIS 2.0 and later standards, this TDMA scheme has been enhanced and is referred to as “ATDMA,” which stands for Advanced Time Division Multiple Access.

ATDMA is primarily used in the upstream direction with a bandwidth of up to 6.4 MHz at 5.12 Msym/sec. It supports modulation types like 8QAM, 32QAM, and 64QAM. The physical layer incorporates FEC (Forward Error Correction), burst interleaving, and a 24-tap equalizer.

Benefits or Advantages of ATDMA

The following are the key benefits of ATDMA:

  • Improved Spectrum Efficiency: ATDMA allows multiple cable modems to access the cable network simultaneously at the same frequency but during different time slots. This increases the overall spectrum efficiency of the DOCSIS system.

  • Robust Physical Layer: ATDMA utilizes FEC (Forward Error Correction) and byte interleaving to mitigate impulse noise and burst noise, resulting in a more robust physical layer.

  • Higher Throughput: Compared to the TDMA used in DOCSIS 1.x, ATDMA supports wider bandwidths and higher-order modulation schemes (8QAM, 32QAM, and 64QAM). This allows ATDMA to support significantly higher throughput rates.

Drawbacks or Disadvantages of ATDMA

The following are the main disadvantages of ATDMA:

  • Susceptibility to Impulse Noise: ATDMA performs less effectively than SCDMA (Synchronous Code Division Multiple Access) in environments with significant impulse noise.

  • No Load Balancing: ATDMA does not inherently support load balancing techniques.