Showing 6 posts (Page 1 of 1)
Advertisement
This page covers LTE testing as per LTE UE compliant to 3GPP conformance test. It covers LTE UE Test and Measurement viz. EVM, receiver sensitivity, maximum power reduction, IQ, spectrum mask, ACLR, RSRP etc.
Calculate the Minimum Detectable Signal (MDS) based on bandwidth and noise figure. Determine the sensitivity of your RF receiver.
Minimum input sensitivity is the lowest power level a receiver needs to decode a signal successfully in Wi-Fi 7. It impacts range, performance in noisy environments, and power efficiency.
Explore receiver sensitivity, SNR, CNR, and noise figure for wireless standards like GSM, DECT, and GPS. Understand how these parameters impact wireless communication.
Learn about Single Ended Bit Error Rate (SBER) testing, how it differs from loopback BER, and its advantages in assessing receiver sensitivity, especially in systems like the CMU200.
Learn about WiFi 6 receiver input sensitivity testing as per IEEE 802.11ax. Understand the test setup, minimum sensitivity requirements, and key parameters influencing the measurements.
Advertisement
RF